8
LEAK TEST
To prevent fire or explosion hazard when testing for a leak:
1.
Always perform the leak test as described below before lighting this appliance or each time the gas cylinder
is connected for use.
2.
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.
Conduct the leak test outdoors in a well-ventilated area.
4.
Do not use matches, lighters or a flame to check for leaks.
5.
Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak, disconnect
the propane supply. Call a gas appliance service shop or your local propane gas supplier.
To perform a leak test:
1. Make 2~3 oz. of leak solution by mixing one part liquid dishwashing detergent and three parts water.
Noted:
make sure control knob is “OFF”.
3.
Apply several drops of solution on each connection and check for bubbles.
4.
If NO bubbles appear, the connection is secure.
5.
If bubbles appear, the connection has the leak, disconnect the part, reconnect, perform another leak check.
6.
If you continue to see bubbles after several attempts, the part is defective and should replace the part.
LIGHTING INSTRUCTIONS
1.
Push in gas control knob slightly and turn to “OFF”.
2.
Turn gas control knob the “ON/MIN”.
3.
Push in gas control knob all the way and hold. Continue to press the ignition button for 15 seconds.
4.
If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5 minutes before
attempting to light the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1.
Push in gas control knob slightly and turn to “OFF”.
WARNING:
For your safety, read and follow the Lighting Instructions in this manual and in the Rating Plate
on the appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR
EXPLOSION HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
CARE AND MAINTENANCE
To enjoy the outstanding performance from your fire pit, make sure you perform the following activities on a
regular basis:
1.
Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2.
While cleaning the fire pit, make sure to keep the area around the burner dry at all times. DO NOT
submerge the control valve assembly. If the gas control is submerging in water, DO NOT use it. It must be
replaced.
3.
Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of
