14
②
Slowly pull down the left and right levers of the bottom laminate film stand underneath the
paper plate down to the edge.
③
The film passes through the back of tension bar and comes out of outlet past the heat roller.
④
Slowly lift the bottom laminate stand to the edge of left and right levers to return it to its
original state.
⑤
When closing the top unit, close it by slowly pulling top and bottom films from the outlet to
prevent formation of wrinkles on the films. Here, be careful not to stretch the film too strongly.
⑥
Return the direction board to its original position.
Do not slant the direction board.
[ 4 ] Set the paper to be processed.
①
Place the paper to be processed on top of paper plate, and adjust the size using lever to
prevent the paper from moving in any direction.
Use a paper with size and thickness compatible with this product.
[ 5 ] Connect power and set detailed settings.
①
Connect power on the right side of this product.
②
Set front and back margins and number of papers to be processed on the operation panel.
Refer to P8~10 for setting.
[ 6 ] Start processing.
①
When [READY] lamp is turned on in red, preparation is complete.
Press [START/STOP] button to start processing.
※ If the machine immediately stops or an error is generated while processing, review the setting
method.
Pull Roller
Heat Roller
Tension bar
Caution
Since each part becomes as hot as the heat roller during use of this product, be careful about burning.
Some errors cannot be resolved without turning the power off.
Settings such as number of papers to be processed are reset with power off and must be reconfigured.
Right spring paper
tube holder
Summary of Contents for AUTO ATLAS-14T
Page 1: ......
