Lamborghini Caloreclima RUBINO PLUS, User Manual

Page: 29 / 56

EN
Cod. 3QE46220 - Rev. 01 - 10/2020
RUBINO PLUS
29
2.9 TIMER SETTING
Press the "TIMER" button once and then the "+" or “-“ button to set the unit's automatic switch-on timer, or press the "TIMER" button
twice and then the “+” or "-" button to set the switch-off time automatic unit.
Setting the auto-start time (TIMER ON)
• Press the "TIMER" button once. The LCD display on the remote control shows the "TIMER ON" icon and indicates the auto-
matic switch-on time instead of the temperature. At this point it is possible to set the auto-start timer.
• Press the "+" or “-“ button repeatedly to set the desired auto-start time. Each time the button is pressed, the time increases by
30 minutes between 0 and 10 hours, while the increase is one hour between 10 and 24 hours.
• Once the "TIMER" function has been set, a delay of three seconds occurs before the remote control transmits the signal to
the air conditioner. Then, after about 2 more seconds, the temperature setpoint appears on the remote control LCD display
again and the "TIMER ON" icon (
7 5 4
1
2
3 6
) remains lit.
Setting the auto-off timer (TIMER OFF)
• Press the "TIMER" button twice. The LCD display on the remote control shows the "TIMER OFF" icon indicating the automatic
switch-on time instead of the temperature. At this point it is possible to set the new automatic auto-off timer.
• Press the ”+” or "-" button repeatedly to set the desired switch-off time. Each time the button is pressed, the time increases by 30
minutes between 0 and 10 hours, while the increase is one hour between 10 and 24 hours.
• Once the "TIMER" function has been set, a delay of three seconds occurs before the remote control transmits the signal to the
air conditioner. Then, after about 2 more seconds, the temperature setpoint appears on the remote control LCD display again
and the "TIMER OFF" icon (
7 5 4
1
2
3 6
) remains lit.
fig. 8 -
CAUTION
• When you select the timer operation, the remote controller automatically transmits the timer signal to the indoor unit for the
specified time. Therefore, keep the remote controller in a location where it can transmit the signal to the indoor unit properly.
• The effective operation time set by the remote controller for the timer function is limited every 30 minute.