EN
Cod. 3QE46220 - Rev. 01 - 10/2020
RUBINO PLUS
24
2. STARTING
2.1 ADVICE ON HOW TO USE THE REMOTE CONTROL
Comply with the following instructions to correctly use the remote control:
1.
Remove the battery if the remote control is not going to be used for a long period of time.
2.
When used, direct the remote control towards the signal receiver of the interior unit (1).
3.
The remote control signal is received up to a distance of 8 meters.
4.
The signal must not be obstructed by any kind of object.
5.
Handle the remote control with care.
6.
The signal could be disturbed by a fast-acting lamp, a fluorescent lamp of the inverter type or a mobile phone.
7.
The remote control should not be left in a place where it could be exposed to direct sunlight, near a stove or another heat source.
N.B. The batteries described in point 1 must be kept in a safe place, well away from children's reach.
2.2 INSERTING/REPLACING THE BATTERIES
To insert/replace batteries, proceed as follows "fig. 3 -":
1.
Remove the cover (1).
2.
Remove the discharged batteries and insert the new ones
(2), making sure that they are positioned as shown in the
diagram in the battery housing.
3.
Fit the cover (3) back in place.
N.B.: Remove the batteries from the remote control when the air
conditioner is not going to be used for a long period of time,
must be kept in a safe place, well away from children's reach.
To safeguard the environment and the safety of persons, always
dispose of old batteries in the specific containers.
fig. 3 -
2.3 POWERING THE AIR CONDITIONER
Press the ON/OFF button ("fig. 4 -") to power the air conditioner.
Remember that the liquid crystal display will always indicate the
last operating mode and previously used functions. Comply with
the instructions if you wish to change the operating mode of the
system.
fig. 4 -
2.4 HOW TO USE THE BUTTONS
By pressing the "MODE" button ("fig. 5 -") it is possible to select
the operating modes (Fig. 3) you prefer, choosing between the
following ones: AUTO - COOL - DRY - HEAT - FAN.
fig. 5 -
1. AUTO
Mode- Automatic
:
this function is selected by pressing the "MODE" button until the relative Symbol appears on the display.
The conditioner automatically sets the suitable operating mode (COOL, DRY, HEAT, FAN) depending on room temperature. The
temperature can be set within a range of 16°C ~ 30°C in 1°C increments.
2. COOL
Mode- Cooling: this function is selected by pressing the "MODE" button until the relative Symbol appears on the display.
The unit begins to operate if the set temperature is lower than that of the room. The temperature can be set within a range of
16°C ~ 30°C in 1°C increments. In this operating mode it is possible to select the fan speed using the "FAN" button and the "+"
and "-" buttons.
Summary of Contents for RUBINO PLUS
Page 55: ...NOTE...
