lamber LP6-dy, Instruction Manual

Page: 37 / 52

37
List ALARMS!
BREAK TANK ALARM
It indicates an anomaly: lack of water from the
net, solenoid valve not functioning.
A3-TEMP.SENSOR
This message indicates that the probe
temperature thermostats of hot water heater is
broken or short-circuited!
Replace the probe.
A2-HIGH TEMP.
This message indicates that the temperature in
the boiler is greater than 105°C.
Chek for the presence of water in the boiler or
the operation of the heating element!
BOILER PROBE FAILURE
This message indicates that the probe of the
boiler is not working properly. In this case the
functioning of the resistance of the boiler and the
Thermocontrol are disabled.
Replace the probe.
TANK PROBE FAILURE
This message indicates that the probe of the
washing tank is not working properly. It is
disabled in this case the functioning of the
washing tank resistance.
Replace the probe.
TANK FILLING ALARM
If after 15 minutes the tank filling is not concluded,
the message TANK FILLING ALARM will be
displayed accompanied by an acoustic alarm.
The dishwasher stops working.
Switch off the machine by pressing ON/OFF
pushbutton.
Check if there is water inside the network or
that the water feeding hose is not twisted or
chocked.
Check the inlet solenoid valve.
CHECK THE WATER LEVEL
This message indicates that, during the wash
cycle and every time that the dishwasher fills with
water, an excessive decrease of the water level
inside the tank has occurred.
The pressure switch advises about the water
lack.
Check if there is water inside the network or
that the water feeding hose is not twisted or
chocked.
Check the inlet solenoid valve.
CHECK THE RINSE TANK HEATING
ATTENTION: if the dishwasher is in the washing
phase (pump is functioning), the cycle will stop.
To delete the message press whatever
pushbutton.
If the rinse tank temperature doesn’t increase of
at least 1 degree every minute, this means that
the rinse tank element doesn’t work).
Replace rinse heating element
CHECK THE TANK HEATING
ATTENTION: if the dishwasher is in the washing
phase (pump is functioning), the cycle will stop.
To delete the message press whatever
pushbutton.
If the tank temperature doesn’t increase of at
least 1 degree every 3 minutes, this means that
the tank element doesn’t work).
Replace ank heating element