lamber LP6-dy, Instruction Manual

Page: 25 / 52

25
PROBLEMS - CAUSES - SOLUTIONS
PROBLEMS CAUSES SOLUTIONS
The machine doesn't catch Main switch is switched off; Turn ON the main switch;
Power plug is not inserted Insert the power plug
The water doesn't go in Water cock closed; Open water cock;
The Overflow is not in place; Reassemble the Overflow in place
The water inlet hose is blocked Change the water inlet hose
Insufficient Washing Wrong detergent or dosage Use anti-foam detergent in the right
dosage and never with cold water;
Detergent is inappropriate Use a non-foaming detergent and
never in cold water;
Low temperature in the tank; Wait until the water gets hot and wait
for the achievement of the ideal
temperature indicator light stop
blilnking
Dirty wash filter; Clean filter;
The washing arms are not free to
rotate Check the presence of obstacles or
the correct positioning of the objets
Insufficient Rinsing Rinsing nozzles blocked; Unscrew and clean nozzles under
running water;
Hydraulic pressure lower than 1
bar - 100 kPa; Wait until the pressure is on or buy a
booster pump;
The machine will not drain Drain hose obstructed Check and remove any obstruction
The filter of the drain pump (if
included) is obstructed Clean the filter of pump suction
The objets are not dry Rinse-aid has not been used or it
has been used only in small
quantity Set the dosage according to the
manufacture directions
Check that the dosing tubes are not
blocked
Clean the detergent suction filters
placed in the tanks
Also check the entry of the water from
the mains and clean the filter may be
clogged
On the objets it forms a
layer If there is a layer of limestone,
the water is too hard Check for the presence of operation
of water treatment system external or
embedded
In the case of a film of starch,
high temperatures during the pre-
washing Not perform manual pre-washing with
temperatures above 30°C
The display shows
A3-TEMP.SENSOR Boiler temperature detector or
tank are faulty Call the Technical Service!
The display shows
A2-HIGH TEMP. Boiler temperature > 105°C Call the Technical Service!
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE