lamber F92-dy, Instruction Manual

Page: 13 / 79

13
ENGLISH
First Section - FOR THE USER
WORKING AND USE
The dishwashing machine can wash up to 600 dishes per hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water;
The correct placing of the objects is an essential condition for a good washing-up result;
We suggest to descale dishes, from time to time, in order to remove calcareous and/or starchy sediments
by soaking it in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following:
Dishes and cups: preference must be given to china or non-porous pottery articles, with smooth surface.
Glasses: choose a glass suitable to be washed in dish-washing machines. Surfaces must be smooth and
bottoms as flat as possible.
INSTRUCTIONS BEFORE WASHING
B
EFORE STARTING THE WORKING OPERATION MAKE
SURE THAT
:
- the cock is open;
- the filters are in their housings;
- the wash arm and the rinse arm are free to
pivot;
- rinse aid and washing powder dispenser
containers are loaded.
T
HEN PROCEED
:
1
- Open the door and put into the tank,
possibly over the pump-filter, about 54 gr.
of detergent in powder. Every 10 cycles add
about
40 gr. of detergent.
If the machine is provided with an automatic
dosing device, make sure that the detergent is
in its container.
CAUTION : Observe the safety notes and
dosage data for the use of chemicals. During
the use of the chemical substance wear
protective clothing, gloves and protective
glasses. Do not mix different cleaning
products.
TURN ON THE MACHINE and
operating state of emergency.
2
- Turn on the power using the switch on the
wall .
You will see the serial number of the machine
followed by the logo Lamber.
Close the door of the dishwasher.
Please pay attention to the opening and
closing of the door of the Dishwasher. Do not
use the machine if you are wearing
clothes/items that could get entangles in the
dishwasher parts. As they can limit personnel’s
regular moving ability!
Press at this point the key switch “A” on the
control panel (draw 1)
At this point the LED will turn green and the
interactive display will show “Fill phase 1” that will
signal the start of the filling phase of the tank.
The filling phase is implemented in two stages.
In STEP 1 begins the load of the tank with water
from the water mains; in STEP 2 continues the
filling but also begins a warm-water washing.
Note: If the machine is equipped with water
softener, during the FILLING PHASE 1 it will be
made to one or more cycles of Regeneration and
a subsequent Resins’ Washing.
Attention : during tank filling don’t open the door
of the dishwasher !