Lambda Genesys 1500W, Technical Manual

Page: 68 / 79

83-507-013 Rev. A
61
Acknowledge
SRQ
111x xxxx
None
Acknowledge SRQ. If retransmission
of SRQ is enabled, it will remain en-
abled for the next SRQ. X xxxx is the
address of the supply in binary.
Test if MD Mode
is Installed
Byte 1
1010 1010
Byte 2
xxxx xxxx
0 or 1
Returns a 0 if not installed or a 1 if
installed. A ‘$’ sign followed by a 2
bytes checksum and Carriage Return
is appended to the data. xxxx xxxx is
the address of the supply in binary.
Supply Initiated
Communications
SRQ 100x xxxx N/A SRQ from supply when in MD Mode.
X xxxx is the address of the supply in
binary.
Table 7-4. SINGLE BYTE COMMUNICATIONS
GEN750W models GEN1500W models
Table 7-4: Current programming range Table 7-5: Current programming range
Model Minimum
(A)
Maximum
(A)
Model Minimum
(A)
Maximum
(A)
GEN6-100 000.00 100.00 GEN6-200 000.00 200.00
GEN8-90 00.00 90.00 GEN8-180 000.00 180.00
GEN12.5-60 00.000 60.000 GEN12.5-120 000.00 120.00
GEN20-38 00.000 38.000 GEN20-76 00.00 76.00
GEN30-25 00.000 25.000 GEN30-50 00.000 50.000
GEN40-19 00.000 19.000 GEN40-38 00.000 38.000
GEN60-12.5 00.000 12.500 GEN60-25 00.000 25.000
GEN80-9.5 0.000 9.500 GEN80-19 00.000 19.000
GEN100-7.5 0.000 7.500 GEN100-15 00.000 15.000
GEN150-5 0.000 5.000 GEN150-10 00.000 10.000
GEN300-2.5 0.000 2.500 GEN300-5 0.000 5.000
GEN600-1.3 0.000 1.300 GEN600-2.6 0.000 2.600
NOTE:
The power supply can accept values higher 5% than the table values, however it is not recommended to
program the power supply over the rated values.
Table 7-6: OVP programming range Table 7-7: UVL programming range
Model
Rated Output Voltage (V)
Minimum
(V)
Maximum
(V)
Model
Rated Output Voltage (V)
Minimum
(V)
Maximum
(V)