83-507-013 Rev. A
8
1.2.9 Cooling and mechanical construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken to allow free air-
flow into the power supply via the front panel and out of the power supply via the rear panel. The Gene-
sys
TM
power supplies have a compact and lightweight package, which allows easy installation and space
saving in the application equipment.
CAUTION
1.3 ACCESSORIES
1.3.1 General
Accessories are delivered with the power supply or separately upon ordering. The list below shows the
possible accessories and ordering numbers.
1.3.2 Serial Link Cable
Serial link cable, for linking power supplies by RS485 communication is provided with the power supply.
Cable description: 0.5m length, shielded, RJ-45 type plugs, 8 contacts (P/N:GEN/RJ-45).
1.3.3 Misc.
hardware
∗
DB25 plug (AMP, 745211-2).
∗
Strain relief for AC cord (for 1500W models only).
∗
Output terminal shield
1.3.4 AC
cables
AC cables are not provided with the power supply. If an AC cable is required, it should be ordered ac-
cording to following:
For 750W Genesys
TM
power supplies:
Part No.
Market
Description
NC301
(GEN/U)
USA
13A 125V, unshielded, 2m typical length, with IEC320 connector on one end
and NEMA-5-15P connector on the other end.
NC302
(GEN/E)
Europe
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end
and INT’L 7 standard VII, dual earthing.
NC303
(GEN/O)
General
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end
and unterminated stripped wires on the other end. Use the cable only with
plug approved by the national safety standards of the country of usage.
NC305
(GEN/J)
Japan
13A 125V,unshielded, 2m typical length, with IEC320 connector on one end
and Japan type plug on the other end.
NC306
(GEN/GB
)
UK
10A 250V unshielded, 2m typical length, with IEC320 connector on one end
and UK type plug on the other end.
For 1500W Genesys
TM
power supplies the recommended AC cable (customer supplied) is:
25A 250V, 3x12AWG, outer diameter: 9-11mm, rated 60°C min., 3m max.
length. Add a non-locking plug approved by the national safety standards of
the country of usage.
1.3.5
Serial Port Cables
Refer to Section 7.5
Observe all torque guidelines within this manual. Over-torquing may damage
Unit or accessories. Such damage is not covered under manufacturers war-
