Lambda 2U GENESYS 5kW, Technical Manual

Page: 15 / 80

83-515-000 Rev. A
8
1.2.9 Cooling and mechanical construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken to allow free
airflow into the power supply via the front panel and out of the power supply via the rear panel. The
Genesys
TM
power supplies have a compact and lightweight package, which allows easy installation
and space saving in the application equipment.
1.3 ACCESSORIES
1.3.1 General
Accessories are delivered with the power supply or separately upon ordering. The list below shows
the possible accessories and ordering numbers.
1.3.2 Serial Link Cable
Serial link cable, for linking power supplies by RS485 communication is provided with the power sup-
ply.
Cable description: 0.5m length, shielded, RJ-45 type plugs, 8 contacts (P/N:GEN/RJ-45).
1.3.3 Misc. hardware
∗
DB25 plug (AMP, 749809-9).
∗
AC Input plug connector (Phoenix Contact, PC6/4-STF-10,16)
∗
Strain relief for AC cord.
∗
Output terminal shield
∗
Plastic legs for bench mounting.
∗
Output bus bar connection hardware.
1.3.4 AC cables
AC cables are not provided with the power supply.
Refer to Table 1-2 for recommended AC input cables (customer supplied). Add a non-locking plug ap-
proved by the national safety standards of the county of usage.
AC Input Range AC Input Cable
190-240V~, Three Phase
4 x 12AWG (3 wire plus safety ground), stranded
copper, 300V, 60°C minimum, rated for 25A. 3m max.
length, outer diameter: 9~11mm.
380-415V~, Three Phase 4 x 14AWG (3 wire plus safety ground), stranded
copper, 600V, 60°C minimum, rated for 15A. 3m max.
length, outer diameter: 9~11mm.
Table 1-1: Recommended AC input cable
CAUTION
Observe all torque guidelines within this manual. Over-torquing may damage
Unit or accessories. Such damage is not covered under manufacturers war-