D
From inside enclosure, using wall rail holes
as a guide, drill (dia 2,8mm), fit cup washer
& screw fixed panel to wall rail using
3,5 x 10 long pan head screws.
Push on decorative cover caps (3 places).
Loosen clamping screw, & fit bracing arm over
glass as shown, position bar such that wall end
sits flush onto tiled wall. Mark hole position, drill
(dia 8mm), plug & affix bracing arm to wall.
Ensure gasket & screw pad are against glass faces
& re tighten glass clamping screw
dia 5 x 60 lg
E
Select & fit appropriate hand
wall rail top cap
&
fit hinge top cap.
With ‘drip strip’ to inside, select appropriate hand seal end caps (left /right).
Apply clear silicone sealant to hinge end cap & push into seal.
Keeping hinge end cap against bottom hinge, push seal upward onto bottom edge
of glass (Note : seal may be‘wetted’ to ease fitting).
Apply clear silicone sealant to outer end cap & push into seal & upto glass edge.
Wipe off excess sealant with a damp cloth.
Gasket
Screw
Pad
