With screen pushed inward over bathtub, apply continuous bead of silicone sealant as
indicated EXTERNALLY ONLY.
Note : If NOT using
supplied bottom seal, ensure silicone
sealant is applied over ‘dotted’ length also!
G
F
A) Tighten screw fully into internal boss.
B) Fit rubber washer & sleeve onto screw
C) Pass screw through glass, fit rubber washer & decorative washer
onto screw then tighten screw into towel rail by turning internal
boss until rail is secure. Additional tightening can be achieved by inserting (dia 2,8mm)
drill bit or 2,5mm hexagon wrench (allen key) into the internal boss cross hole.
Towel Rail Models
Note : Towel Rail used on S
is
a different style (straight bar),
but is affixed in the same way.
S55
Towel Rail
Internal
Boss
Rubber
Washer
Decorative
Washer
Rubber
Washer
Sleeve
Screw
