47
Setpoint increments/decrements in 1.0
Increase setpoint by selected increment level
Decrease setpoint by selected decrement level
Stores set point in flash memory
Running the Pump
The pump can be switched on by pressing the PUMP button on screen. The box will turn from grey to
green which indicates that the pump is on. By clicking the PUMP button again, the pump will switch off
turning the box back to grey.
Note: Pump ON/OFF function is disabled during running of machine.
Figure 37 Running Pump
Choosing the Coolant Setpoint
The Coolant setpoint can be set by choosing values using the arrows and changing the increments
accordingly. By clicking on the increments, the increment can be changed from 0.1 to 1.0 and vice
versa.
Running the system
The system can be run by pressing the RUN button on screen. The box will turn from grey to green
which indicates that the machine is running. In order to switch OFF the machine, click the button again.
Figure 38 Running the Machine
Summary of Contents for Nextreme Series
