laguna SuperMax SuperBrush 49, Owner'S Manual, Page: 17 / 42

LAGUNATOOLS.COM 17
F
igure 7A & B: Shipping Arbor and Bearings
8. Installing brush head;
A. Install brush head (if not already installed) by removing brush head
from shipping box.
B. Slide one bearing (from Shipping Arbor) on each end of the brush
shaft. Do not yet tighten the set screws for the bearing collar, Fig. 7B.
C. Place the shaft key into the key slot of the drive shaft of the brush head.
D. Slide the pulley, Fig. 7A (from Shipping Arbor) onto the drive shaft over
the key.
E. Raise the main motor by using the hand crank, Fig. 7A, at the top of the
column to lift the motor.
F. Place the brush head into the brush machine while holding the drive
belt out-of-the-way.
G. Center the brush head over the conveyor and install Mounting Bolts,
Fig. 7B, from the flange of the bearing into the mating bracket of the
brush machine. Tighten the bearing mounting bolts.
H. Tighten the two set screws, Fig. 7B, in each bearing collar to secure the
brush head shaft to the bearings.
I. Align the pulley of the brush head with the drive pulley of the main
motor. Secure by tightening the set screw(s) in the driven pulley.
J. Lower the main motor for proper tension of the drive belt. Proper
tension is slight deflection of the drive belt when pressed from the side.
K. Make sure all bolts and set screws are tight.
Mounting Bolts (2)
Set Screws (2)
Hand Crank, motor
Pulley
Shipping Arbor
Bearings (2)