laguna Sheartec II JX 8, Owner'S Manual, Page: 20 / 47

20 JX|8 Sheartec:II Jointer \ Setup Assembling
Calibrating the Thickness Scale
FIGURE 8: THICKNESS SCALE
FIGURE 9: LOCK PIN
1. Loosen the Infeed Table locking handle by rotating counterclockwise (Fig. 8).
2. Pull and hold the Lock Pin (Fig. 9) while positioning handle to 1/64”. Tighten handle.
3. Make a test cut half-way on sample material. Measure The depth of cut/stock removal on the sample.
If not
1/64”, adjust pointer to actual cut dimension by loosening the Phillips screw and adjusting red
pointer and tightening the Philips screw.
Adjusting the Fence
The fence can be adjusted to use all or a portion of the cutterhead. To adjust, loosen the Locking Handle
(Fig. 10) and turn the Adjustment Knob to position fence in desired location.
NOTICE! The 90-degree position has an included
reference STOP (Fig. 11). To adjust, flip the stop
into position, loosen the lock nut and rotate the
adjusting screw until the fence is at 90 degrees to
the table. Tighten the lock nut and flip the stop
back if making other angled adjustments. To check
the 90 degree setting, place a square on the outfeed
table and against the fence.
FIGURE 10: FENCE SLIDE COMPONENTS
To adjust the fence perpendicular or angled to the bed, loosen the Locking Lever (Fig. 11) and adjust the
fence to the desired position.