laguna Sheartec II JX 8, Owner'S Manual, Page: 15 / 47

JX|8 Sheartec:II Jointer \ Setup Placement & Unboxing 15
ACHIEVING.
EMPT ANY PROCEDURE THAT YOU FEEL IS UNSAFE, OR THAT YOU DO NOT HAVE THE PHYSICAL CAPABILITY
A

TT
IF YOU HAVE ANY DOUBT ABOUT THE PROCEDURE, SEEK PROFESSIONAL ASSISTANCE. DO NOT ATTEMPT ANY
PEOPLE TO DO THE JOB SAFELY.

THE MACHINE WEIGHS 495 LBS (224KG). ENSURE THAT YOU HAVE ENOUGH
WARNING!
6. Allow an area for the storage of blanks, finished products and tools.
Unboxing
This step may require a forklift. The components and the machine are heavy, be careful when lifting and
handling it! Failure to comply may cause serious injury and/or damage to the machine and/or property!
Use of a forklift to remove the stand and jointer tables from pallet is a good procedure. A forklift can
also be used to place the jointer body (tables) on the stand.
NOTICE! The jointer body (tables) can also be lifted with a harness and forklift.
FIGURE 3: CRATED MACHINE
The Jointer comes packed in two crates. Before attempting to assemble this machine, follow these
directions:
1. Remove the stand crate from the pallet and place on the floor.
2. Cut any banding and open crate. Remove the stand from the crate.
3. Casters may be factory installed, if not, install leveling feet or casters into stand, or place on a mobile
base.
4. Remove the top covering the jointer body (tables), typically screwed (or nailed) in place.
5. Remove the two ends of the crate.
6. Remove any excess packing or crating material from around the jointer body.
7. Remove any packing material such as cardboard or foam.
8. Using the information below, ensure that all parts are present and in good condition.