laguna PX-16 SHEARTEC II, Owner'S Manual

Page: 30 / 56

PX-16 SHEARTEC II PLANER 30
Make sure level the Carbide Blade Roller using a Calibrated Leveling Indicator & Leveling Block. Using these
instruments verify readouts of Bottom Dead Center of the Carbide Blade Roller.
3.) To level and secure the Top Roller, use the same technique, and use the same Calibrated Leveling Indicator &
Leveling Block as applied to the Carbide Blade Roller.
Make sure the Top Roller is adjusted to the same verification readouts at both ends of the Top Roller, Bottom
Dead Center, the same as the Carbide Blade Roller.
4.) When appropriate level is reached, on the Table Height Adjustment Wheel side, open or remove the Panel
Cover, just below the main Top Roller Axel
(Figure H) there is Adjustment Bolt to adjust the height and the
Hex Nut, tighten to secure and lock height of the Top Roller.
3c.) To Adjust Pressure & replace the pressure Springs for the Top Roller: