laguna MJOIN8012-0130, Manual

Page: 14 / 34

14
Fitting the drive belts.
Cover
Motor pulley
Cutter head pulley
Adjusting bolt
1.
Remove the cover and side panel.
2. Loosen the motor adjusting bolts. Move the
motor to the top of the slots and clamp.
3. Fit the belts over the motor and cutter pulleys.
4. Loosen the motor adjusting bolts and lower the
motor. Tighten the bolts.
Note. The belts should be tensioned so that with
moderate pressure there is approximately 3/16 inch
deflection.
5. Re fit the side panel and cover.
Fitting the on / off switch.
Fit the on / off assembly to the side of the table as
shown.
Mounting bolts