ENGLISH
2
Submersible Pond and Water Feature Pumps
For freshwater and submersible use only
Read thoroughly prior to installation and operation
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To guard against injury, basic safety precautions should be observed,
including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Follow all important notices on the appliance before using the pump.
Failure to do so may result in loss of fish life and/or damage to this appliance.
2.
DANGER
– To avoid possible electric shock, special care should be taken since water is employed in the
use of pond equipment. If pump is damaged in any way, do not attempt repairs yourself; return the
appliance to the store where it was purchased if still under warranty.
A 10mA or 30mA Residual Current Device (RCD) (or GFCI- Ground Fault Current
Interrupter) MUST be fitted to the mains (main power supply) of the pump only.
A. If the appliance shows any sign of abnormal water leakage or if RCD (or GFCI- Ground Fault Current
Interrupter) switches off, disconnect the power supply cord from mains (main power supply) and remove
pump from water.
B. Carefully examine the appliance after installation. It should not be plugged if there is water on parts not
intended to be wet.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped
or damaged in any manner. The power cord of this appliance cannot be replaced; if the cord is damaged,
the appliance should be discarded. Never cut the cord.
3. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
4. The pump is equipped with a thermal overload safety device. In the event of any overheating of the motor,
this device automatically switches off the pump. The cooling time is roughly 15 to 20 minutes, and then
the pump automatically comes on again. If the overload cutout is tripped, it is essential to identify and
deal with the cause of the overheating.
5. To avoid injury, do not touch moving parts or hot parts.
6.
CAUTION
– Always unplug or disconnect all appliances in the pond from the electrical supply before
placing hands in water, before putting on or taking off parts and while the equipment is being installed,
maintained or handled. When inserting or removing the pump from the water, always pull out the main
electrical plug. Never yank the cord to pull the plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use. Never lift the pump by the cord or floating
switch. Use the unit handle.
7.
CAUTION
– This is a Pond Pump. The pumps are designed to pump clean water or water containing solids
with a diameter of up ¼, depending on model.
This Pump Has Been Evaluated For Use With Freshwater Only.
Do not use this pump for other than its intended use (i.e.: do not use in swimming pools, bathrooms, etc.).
The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe
condition.
Jolie
Products,
Inc
