laguna LT14 series, User Manual

Page: 12 / 55

12
Identification
There is a plate at the back of the machine
listing all the manufacturing data, including the
serial number, model, blade length, etc.
Tension scale
Tension scales are designed to indicate the
compression of a spring. As a rule, the greater the
spring compression, the greater the tension on the
blade. The tension scale does not register until the
blade is relatively taut and is located on the inside of
the body vertical post. The tension scale is a general
reference and not a rule.
Tilt and Tension Mechanism
The upper wheel is attached to the tilt and tension mechanism. This mechanism adjusts the
wheel so that the bandsaw blade can be adjusted for tracking. This is achieved by a
screwed handle at the back of the machine that pushes on the mechanism and adjusts the
axis of the wheel so that it runs true with the lower wheel. The second function is to tension
the blade, which is achieved by adjusting the upper flywheel vertically. A handle is located
at the top of the bandsaw and, when rotated, will move the wheel up or down. The machine
has a quick-acting blade release mechanism, which is located at the back of the machine
and will remove the tension from the blade to speed the removal and fitting of blades. The
mechanism has a spring that helps to keep the tension constant as the blade expands and
contracts with the heat generated by the cutting action.
Fence
The fence is located to the left of the blade and is used to assist in parallel cuts. It is
adjustable for the drift of the blade and also the thickness of the cut.
Where to locate your machine.
Before you remove your bandsaw from the pallet, select the area where you will use your
machine. There are no hard-and-fast rules for its location, but below are a few guidelines.
1. There should be an area at the front and back of the machine suitable for the length of
wood that you will be cutting. If you intend to use your saw for scrollwork, this may not be
important but should be considered at this stage.
2. Adequate lighting. The better the lighting, the more accurate and safely you will be able
to work
3. Solid floor. You should select a solid flat floor, preferably concrete or something similar.
4. Close to power source and dust collection.
Serial and data plate