laguna CEF236230175, Setup And Maintenance Manual

Page: 17 / 45

Fusion Tablesaw
17
Loose Parts & Overview
Your new machine has been mostly assembled at the certified ISO 91001 factory where it was made. Some parts must be assembled by
the purchaser. Please read all steps first before proceeding with step one.
(5) M8x1.5+ lock washer
+ nut
(5) Square Head
8x1.5+ nut
Fence hooks (step 2)
1.
3.
2.
12.
[See explanation of steps on the following pages.]
10.
6. 7. 8.
9.
4.
11. 5.
General Setup
1. Attach short rear fence support 2. Attach long rear fence support
1. Attach the short rear fence support
2. Attach the long rear fence support
3. Level the rear rails and fasten
4. Attach T-Slot bolts to front table
5. Insert long front rail fence support
6. Insert short front rail and switch
7. Join front fence supports
8. Align the entire front rail to blade mark
9. Level and fasten the front rail
10. Insert fence
11. Level the saw by adjusting casters
Use the supplied wrench and Alan key to loosely
fasten (2) bolts, lock washers, washers, and nuts
to the short rear fence guide and the back left of
the table.
STOP BEFORE TIGHTENING: Keep
bolts loose until entire rail assembly is in place to
properly level rail.
Repeat step 1 for the longer rear fence section with
(3) bolts, lock washers, washers, and nuts. Use the
same assembly diagram in Step 1.
NOTICE: If the fence hooks are not yet installed,
now is a good time to do so.
3. Level the rear rails and fasten
4. Attach T-slot bolts to front table 5. Insert the long front fence support
To level the rear fence with the table
top, place a rigid straight edge on top of
the rails. Apply downward force at both
arrow indicators and simultaneously
tighten the bolts with the supplied Allen
key and wrench.
Loosely fasten the (5) square headed bolts,
(5) washers, and (5) nuts. A couple
revolutions of the bolt will be tight enough.
Prepare to insert the (2) aluminum front rail
sections. Insert the long Front Rail. STOP
BEFORE TIGHTENING: Keep these
bolts loose until the entire rail assembly
is in place to properly level the rail.