1HP One stage Dust Collector Manual
21
ATTACHING THE MOTOR AND DUST CHUTE TO THE FRAME
1.
Place the motor and dust chute on their side.
2.
Align the four holes, two shown at C, on the top of the side
supports (A) Fig. 3, with the four holes on the dust chute (B).
3.
Place a 5/16” flat washer onto a 5/16”x3/4” hex bolt and insert the
bolt through the side support and thread bolt into the tapped hole
on the dust chute and tighten securely.
4.
Repeat this process for the three remaining holes.
5.
Carefully lift the assembly up with the wheels on the bottom and
dust chute on top.
A
A
B
C
Fig.3
NOTE: Motor not shown in this figure.
