laguna 18bx, Owner'S Manual

Page: 25 / 70

25
The fence support and the fence are held off the table with a nylon-support Allen screw. This
screw ensures that the fence and the fence support do not damage the table. The screw is
adjustable to compensate for wear.
Fitting the table insert
and Fence Stopper
The machine is supplied with a removable table insert that is held
in position with a screw. The table insert is removed when blades
are removed or fitted to the machine. The insert is made of soft
aluminium so that if the blade wanders and contacts the insert,
there is less chance of damaging the blade. Adjusting screws are
provided to adjust the insert vertically level with the table. The
insert comes factory set, but should adjustment become
necessary, place the insert in the table with the screw fitted. Place
a straight edge across the table and insert and adjust the screws
so that the table insert is level with the top of the table.
Fence in high position
Allen key
Support Allen screw
Table insert
Fitting the Fence Stop
The fence stopper can be used to control the length of cut for non
through cuts .
To set the stop in place,
the scale should be
attached into the T-slot on top of the fence when it is on the
vertical position. The “0” on the scale should be adjusted and set
to be align up to the front tip of the blade. Then refer to the scale,
slide the fence stopper to the desired cutting length behind the
front tip of the blade as shown in the scale, then fix the fence
stopper in place by tightening down the quick release handle.