Laguna Tools Platinum 18/47 Series, Manual

Page: 16 / 28

16
Face plate allen set screws
Face plate locking / unlocking rod
Index pin
Clean Morse taper
Drive centre fitted
Fitting the drive centre in the head stock.
To remove the face plate from the hea d stock spindle.
Loosen the two allen set screws .
Insert the face plate locking / unlocking rod into the hole in th e face plate .
Fit the index pin to lock the spindle an d unlock the face plate .
Ensure that the bore of the head stock i s clean .
The drive centre has a number No 2 Morse taper that fits into the head stock . Push the
centre into the head stock bor e firmly, and ensure that it is securel y located .
To remove the centre, push the remova l shaft into the back of the head stock, an d
give it a sharp knock. This will remov e the drive centre .