Laguna Tools MTST5S-0135, Operating Manual

Page: 15 / 59

3. ASSEMBLY & SETUP
13
3-5 FITTING OR CHANGE SAW BLADE & RIVING KNIFE
I. SAW BLADE FITTING
This machine is designed to accommodate the saw blade with the size up to 305mm,
but every time you change blade, the blade appropriate size of riving knife must also
to be changed to match the size you installed.
Note: please wear gloves during installation or replacing of saw blades.
1. Disconnect the power source.
NOTE: Serious personal injury could occur if you connect your machine to the
power source before you change blade.
2. Move the blade tilt to 0
H
and raise the saw blade as high as it can be adjusted.
3. Push the saw guard up and loosen the fixed bolts of insert. Take off the insert
plate.(Fig.3-5.1 & 3-5.2)
4. Open the red cover, R (Fig. 3-5.2a).
Note: the red cover is used as a guard for protecting operators from injured by
the blades
Figure 3-5.1
Figure 3-5.2 Figure 3-5.2a
R