![background image](http://html1.mh-extra.com/html/laguna-tools/lt14-sel/lt14-sel_manual_3337187015.webp)
REV. 1
15
Remove the locking nuts, washers and grease. Move the center nut as far as it can
go towards the fence rail. Fit the locking nuts/washers to the two outside bolts from
the underside of the table. Fit the fence to the rail and line it up with the miter slot.
Adjust the nuts so that the fence is parallel with the miter slot. An easy way, is to fit
a steel straight edge in the miter slot and adjust the nuts so that the fence contacts
all along the straight edge. Tighten the nuts and re-check that the fence is parallel
with the miter slot.
Check that the fence touches the table at one point only (see above) this will reduce
friction when moving. If the fence is not as shown, loosen the nuts under the table.
Move the rail up or down and retighten. Tighten the center bolt nuts. Care must be
taken to tighten from both the underside of the table and the outside at the same
time to avoid bending the rail and/or putting strain on the cast iron table.
Summary of Contents for LT14 SEL
