laerdal AED Trainer 3, Directions For Use Manual

Page: 25 / 74

25
REGULATORY
INFORMATION
REGULATORY INFORMATION
The product is in compliance with the essential requirements of Directive 2014/30/EU on electromagnetic
compatibility through compliance with:
• EN 61000-6-3 Electromagnetic Compatibility (EMC) - Part 6-3: generic Standards - Emission standard for
residential, commercial and lightindustrial environments
• EN 61000-6-1 Electromagnetic Compatibility (EMC) - Part 6-1: Generic standards - Immunity for residential,
commercial and light-industrial environments
The product is in compliance with FCC Part 15 Radio Frequency Devices, Subpart B - Unintentional Radiators (May
2004). This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
GLOSSARY OF SYMBOLS
Symbol Definition
The product is in compliance with the essential requirements of Council Directive 2014/30/EU
on electromagnetic compatibility (EMC) and Council Directive 2011/65/EU on restriction of the
use of certain hazardous substances (RoHS).
LATEX
This product does not contain natural rubber latex..
N25270
Australian EMC Compliance Mark
Printed on recycled paper.
This appliance is marked according to the European directive 2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE).