laerdal AED Trainer 3, Directions For Use Manual

Page: 8 / 74

8
SETUP
Setting up the AED Trainer 3
To set up the AED Trainer 3 for operation, you will need to ensure that the Operating System Card is properly installed,
install the batteries, select a different language if you do not wish to use US English, and connect the training pads.
Instructions for each of these tasks follow.
CHECKING THE OPERATING SYSTEM CARD
The AED Trainer 3 Operating System Card contains the operating system for the AED
Trainer 3. The AED Trainer 3 is shipped with the Operating System Card pre-installed.
To remove, re-install, or replace the Operating System Card, follow the steps below:
1 Squeeze the latch on the battery compartment lid to release the lid. Lift out the
lid and set it aside.
2 Check that the Operating System Card is installed in the slot at the top of the
compartment. If not, install the Operating System Card in the orientation shown.
INSTALLING THE BATTERIES
The AED Trainer 3 requires four AA size alkaline batteries. To install or replace the
batteries in the AED Trainer 3, follow the steps below:
1 Squeeze the latch on the battery compartment lid to release the lid. Lift out the lid and set it aside.
2 Install four AA size alkaline batteries in the battery compartment oriented as illustrated inside the compartment.
Note: Use only fresh batteries of the same type.
3 Replace the battery compartment lid.
4 Return the AED Trainer 3 to its case.