CE COMPLIANCE & FCC
Please help the environment by disposing of your product responsibly at the end of its life.
The wheeled bin symbol indicates that this product should not be disposed of in your household
waste containers. Instead, the product should be disposed of by using a designated collection
point for the recycling of waste electrical and electronic equipment, The Waste of Electrical and
Electronic Equipment(WEEE) Directive (2002/96/EC) requires that the best available recycling
techniques be employed to minimize the impact on the environment. Recycling electronics helps
by keeping harmful chemicals out of the environment, and also saves money by reusing precious
metals. Remove any batteries and dispose of them and the product at your local authority's
recycling facility. For more information about where you can drop off your waste equipment for
recycling, please contact your local city office, your household waste disposal service or the
location where you purchased this product.
This is to certify that the following products conform to the requirements of the RED Directive
2014/53/EU and that all essential test suites have been carried out.
Declaration of Conformity for RED Directive
In accordance with IEC 17050-1
Changes or modifictions not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,there is no guarantee that
inteference will not occur in a particular installation. IF this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receive
is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful inteference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
30
www.LAEGENDARY.com
CE Compliance
& FCC
