17
www.LAEGENDARY.com
Troubleshooting
TROUBLESHOOTING
PROBLEM
SOLUTION
Car will not pair with
the remote
Scratched top
The RC car comes with a protective plastic film that needs
to be removed prior to using the car.
If a new truck shell is needed, it can be ordered through our
website
www.laegendary.com
Steering not working
properly
1. Replace the batteries of the remote with brand new ones
and fully charge the car battery.
2. Turn off the switch on the transmitter, then on, and
pair again. Make sure not to touch the throttle when pairing.
3. Clean the steering arm set and make sure the arm is still in
place, connected to the car.
4. Check the light of the transparent wire coming out of the
car; it should be a solid red.
5. Unplug the wires connecting the servo and the ESC, then
pair the car with the transmitter again.
This is to check the defective part; if the car pairs with the
remote, then the servo might be the problem.
6. Servo and remote controller can be ordered through
our website
www.laegendary.com
Reverse command
not responding
When the car is moving forward in order to go in reverse
please execute the following commands on the remote:
first throttle push will bring the car to a stop and in
neutral mode. The second throttle push will make the car
go in reverse. (please refer to Transmitter Instructions in
this User Manual)
Car going on its own
and not responding
correctly
Do not press any buttons on the remote control while
pairing with the car because it will recognize that command
every time.
Rebind the remote and car and turn them on within
3 seconds so you reset the commands and car
responds properly.
1. Our SONIC car has a thermal protection feature.
When the ESC detects that the temperature is too high, it
will automatically start thermal protection.
Thus, it needs to be switched off and wait for a few minutes
to cool the temperature down.
