LaCie 12big Rack Network
Module Removal & Replacement
User Manual
page 45
5.10. Replacing the Boot Drives
CAUTION:
When handling drives, ensure that they are placed (and
stored) on a cushioned surface.
You can replace individual boot drives or the complete boot drive
module.
CAUTION:
Power down and wait 30 seconds for drives to spin
down before removal
1. To access the boot drive module, release the enclosure top
cover by turning the lock mechanism to the “unlocked “position
and slide the cover back until it stops (see
Fig. 25
).
2. Slide the cover forward, lifting at the same time to completely
remove the cover.
3. Remove the CPU/memory ducting.
4. Unscrew the two screws securing the fan ducting and remove
the ducting.
5. To remove the module, release the single securing screw at the
top of the module and the two screws at the side of the enclo-
sure (see
Fig. 36
).
6. Lift the module assembly out of the enclosure to access the boot
drives.
7. Disconnect the power cord and the data cable(s) from the drive(s).
8. Remove the two screws and spacers from the side of the cage
facing the CPU.
9. Slacken the four screws at the top of the cage and unplug the
PCB. If two drives are fitted you must also slacken the four at the
bottom of the cage as well.
10. To release the boot drive(s), remove the four securing screws
completely from the top (and bottom if two drives fitted) of the
cage.
11. Fit the new boot drive in the module and retain with the screws
removed at step 8 (do not tighten the screws).
12. Plug in the PCB and when the drive(s) and PCB are aligned cor-
rectly, tighten the screws inserted at step 11.
13. Reconnect the power and data cables.
continued on the next page >>
Fig. 36 - Replacing Boot Drives
Fig. 37 - Boot Drive Removal Label
