INSTALLER’S MANUAL
CHANGING GAS TYPE (Changing the Jets on a Gas Cooker)
HOB :
►
Lift the air ring up to reveal the injector (see
A
, figure
1
).
►
Replace the injectors (see
B
, figure
1
) in accordance with table
5
in appendix
0
( Ø in 1/100
mm).
If necessary, the mixer tubes of the lateral burners maintained by a cross-bar (see
C
, figure
2
),
may be released.
To release the tubes loosen screws (see
D
, figure
2
) and then screw (see
E
, figure
3
).
Note
: Ensure that new jet is fitted with a new washer, and tighten into place.
Adjusting the primary air :
►
Put the burner in place and ignite it.
►
Lower the air ring to appropriate level for that gas type (see
F
, figure
4
), tabel
6
in appendix
0
.
(flame should be crisp, blue without any yellow).
Lacanche ranges are supplied with the appropriate gas fitting for the gas type specified when the
order is placed. However, the setting must be fine tuned (COMMISIONED) when the cooker is
installed.
The cooker is designed to operate with the gases in table
4
, appendix
0
.
IMPORTANT : Close the mains gas valve before carrying out any works.
IMPORTANT
In case of use with a gas other than that for which the cooker was initially set up, it is cru-
cial to replace the injectors and modify the adjustments as defined below.
CHANGING GAS TYPE
wrench, 12
F
1
3
2
B
C
A
E
D
4
Sully - Ft 124a - GB - Rév 06 - Modifié le : 07/10/2013 13/42
