BA_060 Rev 1B6 Pressure transmitter PASCAL CS
Page 10/20
previous
list entry
list entry
next
list entry
menu item of
parameter list
vorheriger
Eintrag
Eintrag in
Auswahlliste
nächster
Eintrag
Menüpunkt
der Auswahl
Figure 9: Button functions in a selection menue and example with parameter list for measuring units
Setting a numerical value
Numerical values are entered digit by digit. The selected digit flashes and is incremented
with the up arrow button and decremented with the down arrow button. The more signifi-
cant digit will also be incremented or decremented when stepping over zero. If a change of
the active digit would exceed the allowable value (e.g. the lower or upper range limit) the
allowable value will be shown. With the opposite arrow button you can return to the previ-
ous value.
You confirm the selected digit with the middle button and proceed to the next digit.
You can cancel the value entry at any time by pressing both arrow buttons simultaneously.
The device will then switch back to the corresponding menue entry. The partially edited
value will not be saved.
When the right-most digit is selected, the middle button confirms the whole value. "
Stor
"
appears on the display to confirm that the value has been stored and the device switches
back to the menue item for the value.
You can store the partially edited value at any digit position by holding the middle button
until "
Stor
" appears on the display (approx. two seconds).
menu item
for value
a)
b)
c)
> 2 s
Figure 10: Button functions for entering numeric values a) limit to allowed values, b) changing one digit,
c) incrementing the more significant digit when stepping over zero
