BTA 060, Rev 1K1
Page 5/18
4
Operation
During device operation, take care that the device remains within its intended temperature
range, that its maximum operating pressure is not exceeded and that it is not harmed by
the medium to which it is exposed. No other monitoring is necessary.
Permissible ambient temperature: -20 °C to +85 °C
Permissible overload pressure: See type plate (depends on pressure range)
The measured value is shown on the four-digit display. The LEDs above the display
indicate the switch states of the switching outputs. The LEDs are on, when the switch is
active.
4.1 Setup / Parameterization
You can set or change all adjustable parameters of the device at the device itself. This is
described in detail in the user manual (see below).
The three buttons on the display module are capacitive, not mechanical, therefore they do
not move when pressed. Capacitive buttons sense the presence of your finger when
pressed. Withdraw the finger at least one centimeter after pressing a button. This helps
the device to clearly detect individual keypresses.
If the device comes with an 8-pole connector, you can also configure it with a
communication modem and the PC-Software COMLINE.S. This is described in a separate
manual.
4.2 Maintenance
When properly installed in accordance with applicable specifications, this device is
maintenance-free. However, we recommend an annual recalibration of the device.
The device contains no user-serviceable or user-replaceable parts or components.
5
Removal
Before attempting to remove the device, be sure to first relieve the process system
pressure. Shut off the pressure source for all feed lines and relieve the pressure in them.
Attempting to remove the device from a still-pressurized system may result in
severe injury.
Be sure to de-energize the power supply to the device before disconnecting the electrical
connections. Once this is done, the device may be mechanically removed.
Be sure that residue in the process system and in the device itself do not present a danger
to humans or the environment. During dismantling and removal, the device must be easy
to remove from the process system. Do not apply any force during removal work. After the
device has been removed, seal off the measuring point and mark the open process
accordingly.
Removed devices may contain hazardous deposits and residue. When removing
or transporting these devices, be sure to take appropriate safety precautions.
