10
10
Turning on the device
w
The control unit is ready for opera-
tion when LED indicator lights up and
indicates a voltage between 4.0 and
7.0.
Figure:
Front of the control unit
NOTE: Protect the pigmentation device from excessive
voltage
Disconnect the control unit and mains adapter from the
power supply, when it is not needed.
If the pigmentation device is not required for a long time, it is recommend that
you disconnect the control unit’s mains adapter from the power supply.
Keys
Always start the handpiece with the needle car-
tridge inserted to prevent damage to the hand-
piece.
Start-Stop key
Pressing the
Start-Stop key
activates the
handpiece after a short delay and the needle
stroke starts.
Pressing the
Start-Stop key
again stops the
handpiece and needle stroke.
Speed keys
Minus key
Reduce stroke speed
Plus key
Increase stroke speed
The desired working speed can be set by
pressing the
Minus key
and
Plus key
.
When the voltage is increased, the handpiece
runs at a higher stroke speed.
If the voltage is reduced, the handpiece’s
stroke speed automatically decreases.
Using the pigmentation device for the first time
