14
Loading tape supply
Using LabelTac
®
Loading tape supply
Lift printer cover open. Remove one media cap from the
media supply spindle.
Place a roll of supply on the spindle with the flap coming
up and over the top from the right hand side of the roll.
(a)
When the supply is running through the printer, you want the
‘backing’ side face-down.
Replace the media cap and center
the roll and caps in the middle of the media supply spindle.
Push print head release lever to open print head mechanism.
(b)
Guide the leading edge of the supply under the media guide
bar, between the label guides, through the
(green)
media
sensor and out through the mouth of the printer.
(c)
Adjust the label guides to fit the width of the supply.
Close print head mechanism, making sure the latches are
engaged properly. Close the printer cover.
1
2
3
4
5
6
Summary of Contents for LT9
