LM3606 PRINT & APPLY SYSTEM
USER’S MANUAL
Page 51
Made in the U.S.A.
© 2021 LabelMill
06/01/2021 Model LM3606
FAULT MESSAGES
DISPLAYED FAULT
FAULT
CORRECTIVE ACTION
Memory Checksum
Data lost in serial EEPROM
Consult factory or service provider
Print Time Out
Printer failed to print or
Control failed to receive a “End
Print Signal”
A. Printer Off Line
B. No Label Formats Loaded
C. Check Printer Interface Cable
D. Printer mode incorrect
Tamp Down FLT
Head up limit switch failed to switch
during the tamp cycle.
Cylinder did not move off of reed
switch.
A.
Tamp Cylinder Is Not Up
B.
Miss Adjusted Reed Switch
C.
Faulty Reed Switch
D.
Tamp duration too small
E.
Check programming of Tamp switch
NOTE: Light on reed switch should be on when
cylinder is up
Head Down
Head up limit switch failed to switch
during the tamp cycle.
Cylinder did not return up.
A.
Tamp Cylinder Is Not Up
B.
Miss Adjusted Reed Switch
C.
Faulty Reed Switch
D.
Tamp duration too small
E.
Check programming of Tamp switch
NOTE: Light on reed switch should be on when
cylinder is up
Ribbon Out
Printer is out of ribbon
Check printer for ribbon
Low Ribbon
Printer is low on ribbon
Check printer for ribbon
Label Out
Printer is out of ribbon
Check printer for label stock
4-02
