Document type:
Last modified:
Page:
Based on template: ‘
Technical Documentation.dot
’
Technical Documentation 09-01-16
Page 12 of 21
File: ‘
NLB-60E communication protocol - Revision 2 DRFT 2A.doc
5.2.5 Subnet Serial at Position
Gets serial number for an amplifier at the position given by the ‘value’ field.
Address
Op.
Value
Reply
Subnet.SerialAtPos
X
Where X is a number
ranging from 1 to
60, addressing the
60 possible device
positions in the
NomadLink network.
?
[Serial number]
Note:
If no amplifier is present at the position in the subnet
topology that is addressed zero is returned as serial number.
Examples
Getting the serial number for device at position 5 using:
Subnet.SerialAtPos5 ?
the reply might look like
12345678
5.3 Device messages
The commands in this section affect single devices. All addresses starts with the virual device
name for the addressed device.
5.3.1 Power
Sets / gets the new desired power state for the address amplifier
Address
Op.
Value
0 – Set desired power status to off
1 – Set desired power status to on
=
Reply
[VDN]
.Power
?
0 – Desired power status is off
1 – Desired power status is on
