![background image](http://html1.mh-extra.com/html/la-z-boy-spas/dream/dream_owners-manual_3136112020.webp)
20
For HELP, call La-Z-Boy
®
Spas at 1.800.465.2933.
Before Adding Water
Before adding water, go through these simple steps now to prevent common issues
when setting up your
spa
/ hot tub for the first time. Verify that the following have all
been rechecked.
1. Turn off all power at the main breaker panel.
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened (service T-handles
pulled out) to the heater and all pumps.
4. Check that there are no obvious signs of loose wires or
broken pipes.
5. Check that the two heater unions are tight.
Figure 6 - Valve Open/Closed
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or inside of the
spa / hot tub
itself.
8. With the drain open and filters removed, thoroughly rinse out the
spa / hot tub
with
warm water until the drained water runs clear. Run water through the filtration
canister and jet lines to remove any incidental dust, dirt, and debris that may have
accumulated during shipment or installation. Drain all water completely.
9. Make sure that the
spa / hot tub
drain valve is closed and the cap is on tight (see
page 59).
10. Install the filter(s) in the filtration canister.
11. Check that all of the jets are open (turned full counter-clockwise –
except for 5”
spinner jets which open clockwise
).
12. Now is the best time to clean and polish the surfaces of your
spa
(see page 60).
Figure 7 - Unions Tight
CAUTION:
Do not use a wrench. Over-
tightening may cause damage to un-
ions and gaskets, which will not be
covered the Guarantee.