P a g e
| 20
A factory reset will erase the connection between the display and the thermo-
hygro sensor and require the connection to be re-established.
1. "rES oFF" will start flashing.
2. Use the
Ÿ
UP ARROW key or
ź
DOWN ARROW key to
turn "rES on".
3. Press the SET key to confirm and a countdown timer will
begin counting down from "127" When the timer
displays "dOnE", you must remove the batteries from
the display for 10 minutes. While the batteries are out of
the display, also remove the batteries from the thermo-hygro sensor.
4. After waiting for 10 minutes, insert the batteries into the thermo-hygro
sensor, making sure to align the "+" symbol on the batteries with the
markings on the battery cover and inside the battery compartment.
5. Within 2 minutes of inserting the batteries into the thermo-hygro sensor,
insert the batteries into the display, making sure to align the "+" symbol on
the batteries with the markings inside the battery compartment.
6. Wait 5 minutes for the outdoor weather data to display. If any of the
outdoor data displays "--" after waiting for 5 minutes, follow the "Setting
Up" Procedure near the beginning of this manual or in the Quick Set Up
Manual included with the product.
TO EXIT THE MANUAL SETTING MODE
To exit the manual setting at any time during the manual setting modes, either:
x
Press the MIN/MAX key or the ALARM key to exit SET mode, or
x
Simply wait 30 seconds until the SET mode times out and returns to the
Mode 1 display.
WEATHER ALARM OPERATIONS
The Weather alarms can be set when certain weather conditions are met
according to your requirements. For example, you can set the thresholds for the
outdoor temperature to +104°F (high) and 14°F (low), while enabling the high
alarm and disabling the low alarm (i.e. temperatures <14°F won’t trigger alarm,
but temperatures >+104°F will).
x
If the value meets the condition for high alarm or low alarm, the alarm will
ring for 2 minutes and the value will blink, along with the corresponding icon
("HI AL"/ "LO AL").
