P a g e
| 19
2. Press the
Ÿ
UP ARROW key or
ź
DOWN ARROW key to switch the alarm On
or Off. ("AOFF" = Off; "AON" = On)
3. Press the SET key to confirm and to enter the
WIND DIRECTION DISPLAY
TYPE SETTING
.
WIND DIRECTION DISPLAY TYPE SETTING
The wind direction can be displayed using either compass directions or degree
measurements. N is equivalent to 0° on the compass. The default setting is
compass directions.
1. The wind direction will start flashing.
2. Press the
Ÿ
UP ARROW key or
ź
DOWN ARROW key to
toggle from compass directions to degree
measurements.
3. The next step in the SET mode is the factory reset, so
unless you wish to reset the display to factory defaults,
simply wait until the SET mode times out and returns to the Mode 1 display.
4. If you wish to perform a FACTORY RESET, press the SET key to confirm and
to enter the
FACTORY RESET PROCEDURE
.
SEE WARNINGS
in the FACTORY
RESET section.
FACTORY RESET PROCEDURE
WARNING:
Performing a factory reset will erase all MIN/MAX values and weather data
stored in the display's internal memory and return the weather units settings
back to the factory defaults. If you have not yet uploaded the data to the
Heavy Weather Pro software, the data will be lost.
If you do not wish to reset the display to factory defaults, either:
x
Press the MIN/MAX key or the ALARM key to exit SET mode, or
x
Simply wait 30 seconds until the SET mode times out and returns to the
Mode 1 display.
To reset the display to the factory defaults, follow the procedure below.
WARNING:
