La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 3
Remote Temperature Sensor
Compatible Remote sensors
•
The TX141-Bv3 remote sensor comes packaged with this atomic clock.
Quick Connect
Explanation:
Use the quick connect for an atomic clock and remote sensor that
have been working but lost connection due to interference or low batteries. This is
not the same as a thorough factory reset.
1.
Bring the remote sensor and atomic clock together inside, and place the units
5-10 feet apart with nothing between them.
2.
Hold the MINUS button for 5 seconds. The remote temperature area will flash.
3.
Remove battery cover from the remote sensor and press and release the TX
button to send the signal.
4.
Wait for 2 minutes for the remote temperature to appear on the atomic clock.
If the above procedure does not work, please try the factory reset.
Remote Temperature Signal Strength
Explanation:
The atomic clock will search for the remote temperature remote
sensor for 3 minutes after batteries are installed or when the MINUS button is held
for 3 seconds.
•
The antenna symbol will flash during reception.
•
The temperature display will be dashes “---“.
•
If synchronization fails once, the antenna will lose one bar.
•
If synchronization fails twice, the antenna will lose two bars.
•
If RF (radio frequency) reception fails five times, the antenna symbol will show
without bars.
•
The antenna will show full display with successful RF (radio frequency)
reception.
Dashes show for Remote Temperature
Explanation:
Dashes mean the connection is lost between the atomic clock and
the remote sensor.
often resolve the connection.
can cause loss of connection between the remote sensor and
the atomic clock.
Turn the atomic clock 90 degrees towards the remote sensor to provide better
reception. This allows more antenna surface to face the remote sensor signal.
or
Power Requirements
2-AA
power the remote sensor.
2-AA
power the clock.
We recommend Alkaline batteries for the remote sensor.
