![background image](http://html1.mh-extra.com/html/l-b-white/premier-ts170/premier-ts170_owners-manual-and-instructions_3104820018.webp)
IGNITER AND FLAME SENSOR ASSEMBLY
1. The igniter and sensor assembly is located at the top
of the burner casting. See Fig. 17 or 18 depending
on heater model.
2. Remove the two screws securing the mounting
bracket to the burner.Remove igniter assembly.
3. Disconnect high voltage cable from igniter assembly.
4. Remove the two screws that secure the igniter sensor
to the mounting bracket.
5. To assemble, reverse above procedure.
ATTENTION
■
The igniter and ground rod should be cleaned to
maintain proper ignition.
--
Use steel wool or emery cloth.
--
Rub briskly to remove buildup of dust, dirt ,
and oxide.
■
Check the igniter’s ceramic base for cracks.
--
Replace the igniter if cracks are found.
17
1/2 IN. DISTANCE FROM IGNITER
TOP TO BURNER TOP
MOUNTING BRACKET
IGNITER BRACKET
MOUNTING SCREWS
IGNITER/SENSOR MOUNTING SCREWS
HIGH VOLTAGE IGNITION LEAD
ELECTRODE GAP IS 1/8" &
CENTERED OVER BURNER PORT
BURNER PORT
TOP VIEW
FRONT VIEW
FIG. 17
TS170
FRONT VIEW
TOP VIEW
MOUNTING BRACKET
1 1/2 IN. DISTANCE FROM
IGNITER TO "V" OF
BURNER CASTING
IGNITER BRACKET
MOUNTING SCREWS
IGNITER/SENSOR
MOUNTING SCREWS
ELECTRODE GAP IS1/8" & CENTERED
OVER BURNER PORT
BURNER PORT
FIG. 18
TS080
Summary of Contents for Premier TS170
Page 2: ......