KUDO_RM_ML_1.0
w w w . l - a c o u s t i c s . c o m
5 en
EN
3
INTRODUCTION
3.1
Welcome to L-ACOUSTICS
®
Thank you for purchasing the
L-ACOUSTICS
®
KUDO
®
Multi-Mode WST
®
Enclosure
.
This manual contains essential information on the
L-ACOUSTICS
®
KUDO
®
rigging procedures. Read this manual
carefully in order to make familiar with these procedures.
As part of a continuous evolution of techniques and standards, L-ACOUSTICS
®
reserves the right to
change the specifications of the product and the content of this manual without prior notice. Please check
the L-ACOUSTICS
®
internet website @
www.l-acoustics.com
on a regular basis for latest update.
If the product requires repair or if information about the warranty is needed, please contact an approved
L-ACOUSTICS
®
distributor. In order to obtain the address of the nearest distributor go to the internet website
@
www.l-acoustics.com
.
3.2
Unpacking
Carefully open the shipping carton and check the product for any noticeable damage. Each L-ACOUSTICS
®
product is
tested and inspected before leaving the factory and should arrive in perfect condition.
If found to be damaged, notify the shipping company or the distributor immediately. Only the consignee may initiate a
claim with the carrier for damage incurred during shipping. Be sure to save the carton and packing materials for the
carrier's inspection.
The KBUMP package comprises the following elements:
•
One
L-ACOUSTICS
®
KBUMP
rigging structure with 4 ball locking pins hereafter designated as
‘‘BLP’’
.
•
Two shackles fitted with 22 mm/0.87 in. screw pin, hereafter designated as
‘‘22-shackles’’
.
The KLIFT package comprises the following elements:
•
One
L-ACOUSTICS
®
KLIFT
rigging bar.
•
One shackle fitted with 18 mm/0.71 in. screw pin, hereafter designated as
‘‘18-shackle’’
.
The KJACK package comprises the following elements:
•
Two wheel-handled threaded rods.
•
Two U-brackets attached to support base.
KBUMP
KLIFT
KJACK
Figure 1: KUDO
®
rigging components
