16
rev. 2011-5-26
The
Mode/Prog
key is used to switch between program modes. The spa is factory equipped with
three program modes: Standard, Economy, and Sleep modes. Press the
Mode/Prog
key to enter
mode programming, press the
Cool
key to cycle through to desired mode. The control panel
display flashes until confirmed. Press
Mode/Prog
to confirm selection.
STANDARD MODE
In Standard mode, the system maintains the desired temperature. Note that the last measured spa
temperature displayed is current only when the spa pump has been running for at least 1 minute. The
“STANDARD” icon will display when the Standard mode is engaged.
ECONOMY MODE
Economy mode heats the spa water to set temperature only during filter cycles. The “ECONOMY” icon
will display when the Economy mode is engaged.
SLEEP MODE
Sleep mode heats the spa water to within 20°F (11°C) of the set temperature only during filter cycles.
The “SLEEP” icon will display when the Sleep mode is engaged.
FILTRATION SYSTEM
The spa is factory programmed to filter two times a day for 2 hours. In most cases, this is sufficient
filtration. However, the cycle duration can be adjusted. Refer to the Programming the Control System
section for instructions on how to adjust the filtration cycles. The first cycle begins at 12PM, and the
second cycle begins at midnight. The F1 indicator light will come on when the first filter cycle is on. The
F2 indicator light will come on when the second filter cycle begins.
PROGRAMMING THE CONTROL SYSTEM
1. Clock:
Press the
Time
key then the
Mode/Prog
key to engage the programming mode. Then press the
Warm
or
Cool
key to change the hour setting. Once the desired hour is displayed, press the
Mode/Prog
key again to accept the selection, and move to programming the minute setting. Use
the
Warm
or
Cool
key to change the minute setting. Once the desired minute is displayed, press
the
Mode/Prog
key again to accept the selection and proceed to programming the filter 1 start
time, or press the
Time
key to exit the programming mode.
2.
Filter 1 Start Time:
To set the start time of the first filter cycle, press the
Time
key then the
Mode/Prog
key 3 times to
access the filter 1 start time programming. The control panel will display
SET FILTER 1
and a
flashing “START TIME” icon. Press the
Warm
or
Cool
key to adjust the hour setting. Program
default setting is 12PM. Press the
Mode/Prog
key to accept the hour setting and proceed to
program the minute setting. Press the
Warm
or
Cool
key to adjust the minute setting in
increments of 5 minutes. Press the
Mode/Prog
key to accept the minute setting and proceed to
programming the filter 1 end time.
3.
Filter 1 End Time:
After setting the start time of the first filter cycle, the control panel will display
SET FILTER 1
and a
flashing “END TIME” icon. Press the
Warm
or
Cool
key to adjust the hour setting. Program
default setting is 2PM. Press the
Mode/Prog
key to accept the hour setting and proceed to
program the minute setting. Press the
Warm
or
Cool
key to adjust the minute setting in
