Note: This key may be non-operational in some models.
5. Blower
key
Press the
Blower
key once to turn on the air blower. Press the
Blower
key a second time to turn
the air blower off.
Note: This key may be non-operational in some models.
6. Program
key
Use the
Program
key to display the time or enter Programming menu by press and hold the key for
3 seconds. In Programming mode, the following parameters can be set: time, filter cycle start time,
filter cycle duration, filter cycle frequency, and temperature unit. Refer to the Programming the
Control System section for the programming instructions.
7.
Light key
Press the
Light
key once to turn on the LED light. Press the
Light
key a second time to turn off
the LED light. To select a specific color, after the LED light has been turned off, press the
Light
key within 10 seconds to change to the next color selection. Continue until the desired color is
reached. The color setting will store in the memory when the LED light is turned off for more than
30 seconds. This feature allows the user to retain a favorite color setting. A total of 10 color
settings are available:
-
Ice
-
Blue
-
Red
-
Green
-
Sunburst (yellow and orange glow)
-
Magenta (blue and red glow)
-
Tidal (fade between blue and green)
-
Afterburner (fade between red and yellow)
-
Color Burst Fast (entire color spectrum)
-
Color Burst Slow (entire color spectrum)
8.
Up/Down keys +/-
Press the
Up
key to increase the set temperature. Press the
Down
key to decrease the set
temperature. Press the respective key one time for each degree of temperature change. Press
and hold the key to adjust the temperature rapidly. The current spa water temperature will remain
in the control panel display until a temperature key is pressed. Once the desired water
temperature has been set, the spa will begin to heat.
Note: When selecting the spa operating temperature, it is important to factor in the outside ambient
temperature. A spa cannot operate at temperatures lower than that of the surrounding conditions,
or the operating environment of the spa. For the hot summer months, if cooler water is desired, the
Economy mode can be utilized.
STANDBY MODE
A quick press and release of the
On/Off
key will shut the system down (i.e. to set it to Standby mode) for
30 minutes. The display will toggle between
Sby
and the water temperature. All keys are disabled.
Press the
On/Off
key again to reactivate the system before the expiration of the 30 minutes delay.
17
rev. 2012v1
