34
2. Start pump and operate until all water has been removed,
takes about 10 to 15 seconds.
3. After water has been drained, use an air hose from
compressor and an adapter attached to city water fill. In about
3 to 5 minutes all water will be blown out of system.
4. Pour one (1) cup (12 oz) of non-toxic RV anti-freeze into each
P-Trap, two in sinks and one in bathtub.
To winterize the plumbing system:
1. Turn off the pump.
2. Drain the water heater and the entire water system.
3. Remove the inlet line from the water pump.
4. Make an adapter hose kit to attach to the pump, when
accessible.
5. The open end of the hose is to insert into a gallon jar of anti-
freeze liquid.
6. Position valves as shown.
7. Turn on the pump to supply RV system. You may use four to
six gallons or more.
Using the Water System During Freezing Weather.
Your tow able
RV was not intended to be used during freezing weather unless
special precautions are taken. Water freezes at 32° Fahrenheit in
campgrounds or at home.
There is no product that can be added to the water to ensure freeze
protection when the system is in use, other than RV anti-freeze.
DO NOT drink water which contains anti-freeze.
The flush system is designed and built to rinse waste to holding tank
AFTER waste tank has been drained completely of water and solids.
Attach a fresh water base connection marked “San-a-flush.” Be
sure termination valves are open on holding tank(s).
Open valve to release water into tank for rinsing and cleaning of
your waste holding tank.
Rinse for several minutes to remove any foreign matter from tank.
Remember the moisture content may give you a false reading on
your monitor panel indicating it is full. Allow time to dry out tank or
recharge for next usage.
PDF created with pdfFactory trial version
