― 13 ―
CAUTION
● Always make sure to check the Function Selector Switch is setting to the appropriate range before starting measurement.
● Do not expose the instrument to the direct sun, high temperature and humidity or dewfall.
● When the instrument will note be in use for a long period, place it in storage after removing the batteries.
● Use a cloth dipped in water or neutral detergent for cleaning the instrument. Do not use abrasives or solvents.
● Allowable measurement time at 10A range of current function is 15 seconds. If you carry on making measurement continuously over 15 seconds, it can cause
instrument damage.
Please refer to following explanation of the symbols marked on the instrument or in the manual.
●
Symbols
：
Ground
：
AC
：
DC
：
AC and DC
Ω：
Resistance
：
Diode
：
Buzzer
：
Capacitor
Hz：
Frequency
F
：
Double or reinforced insulation
●
Measurement category
CAT.
Ⅱ
：
Primary electrical circuit of equipment with power cord for connection to outlet.
CAT.
Ⅲ
：
Primary electrical circuit of the equipment, which is supplied power from a distribution board, and cable run from a distribution board to an outlet.
2. Features
This instrument, KEW1012, is a Digital Multimeter which designed for making measurement of the low-voltage equipment.
(1) Designed to international safety standards
(6) Diode and Continuity check function
IEC 61010-1 Measurement CAT.
Ⅲ
300V Pollution degree 2 (7) Auto-ranging function
IEC 61010-031 (Requirements for the hand-held probe)
(8) Frequency measurement function
(2) Accurate true RMS readings of AC current and voltage
(9) DUTY measurement function
regardless of the waveform.
(Express Pulse width / Pulse period as a percentage)
(3) REL function to check the difference of measured values
(10) Current function is protected by fuse
(4) Auto power off function to save battery consumption
(11) Instrument is protected from mechanical shock by holster
(5) Data hold function
3. Specification
● Measuring ranges and accuracy (23±5℃, under the 45%〜75%RH)
Function
Ranges
ＤＣＶ
600.0mV
6.000V
60.00V
600.0V
600V
0〜600V
(5 Auto ranging)
±0.5%rdg±2dgt
±0.8%rdg±3dgt
Measuring range
Overload protection: 600V DC or AC
rms Impedance: 10MΩ
(Only 600.0mV range is approx
100MΩ)
Note
Accuracy
