Kyoeisha BARONESS LM56GC, Owner'S Operating Manual

Page: 37 / 89

With the cutter adjustment nut, adjust the
engagement between the reel cutter (cutting
cylinder) and the bed knife (bottom blade) so
that newspaper (one sheet) will be cleanly
cut by the edge of both blades when the
blades in their entirety come slightly into
contact with each other.
Insert a strip of newspaper into the space
between the reel cutter (cutting cylinder) and
the bed knife (bottom blade) at an angle of
90 degrees. Then, rotate the reel cutter
(cutting cylinder) counter-clockwise (when
you face the mower unit from the left) to
check the sharpness of the blades.
Check the sharpness of the entire range (at
three or four points) of the reel cutter (cutting
cylinder).
If there is a gap between the blade edges:
Loosen (rotate counter-clockwise) the
cutter adjustment nut to apply more
contact pressure between the reel cutter
(cutting cylinder) and the bed knife
(bottom blade).
If the reel cutter (cutting cylinder) is too
tight to turn:
Tighten (rotate clockwise) the cutter
adjustment nut to reduce the contact
pressure between the reel cutter (cutting
cylinder) and the bed knife (bottom blade).
If the blades still cannot cut well:
Perform back lapping of the reel cutter
(cutting cylinder).
2
1
fofmiy-001
Adjustment of Blade Engagement_002
1 Cutter adjustment nut
2 Spring
3.
4.
･
･
･
Adjustment of Cutting Height
Adjust the cutting height to fit your cutting work.
Important
This applies the set cutting height that differs
from the actual cutting height.
Cutting Height and Blade Thickness of Bed Knife
(Bottom Blade)
Important
The recommended minimum cutting heights
are based on those of common greens.
These values are affected by the conditions of
the greens and the machine specifications.
If the green undulation is hard, set it a little bit
higher in order not to damage the green
surface.
The recommended minimum cutting height
according to the blade thickness of the bed
knife (bottom blade) is as indicated below.
Handling Instructions
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-13
Adjustment before Work