Kyoeisha Baroness LM1808, Owner'S Handling Manual

Page: 8 / 44

Pull the lever slowly to prevent
sudden starting. Start the machine
while allowing the belt to slip in
the same way as clutch-slipping.
(Fig. 5)
To stop the machine, depress the brake pedal with your right foot until it hits
the pedal stopper. If the pedal play increases or the brake does not work
properly even if the pedal is depressed up to the stopper, shorten the rod by
loosening the lock nut and screwing in the nut. Adjust it so that the clearance
between the spring bracket and the double nut will be 8-10mm when the pedal
is depressed up to the stopper. (If smaller than 8mm, the brake does not work
properly, and if larger than 10mm, the brake may be damaged.) (Fig. 7)
4-4 Operation and Adjustment of Diff-Lock Pedal
4-5 Operation of Clutch Lever for Right/Left Mowers
4-2 Operation of Travelling Clutch Lever
4-3 Operation and Adjustment of Brake Pedal
If the pedal on the left is depressed, the differential device is locked to
enhance linearity, thus preventing slipping. If the pedal play increases,
make adjustment with the adjusting bolts at both ends of the wire.
Pull this lever to rotate the right/left mowers.
The right and left mowers rotate simultaneously.
A direct change system is adopted
for the change lever. The speed
change positions are shown in the
figure.
◆ Do not change the lever
position during travelling.
4-6 Operation of Clutch Lever for Rear Mower
Pull this lever to rotate the rear
mower.
4-7 Operation of Change Lever
Change lever
Clutch lever
for rear mower
Travelling clutch lever
Clutch lever for
right/left mowers
M 8 lock nut
Compression
spring
Spring bracket
Brake drum
Brake rod, front
Brake rod, rear
Brake pedal
Step, right
Pedal stropper
(Fig. 5)
(Fig. 7)
(Fig. 8)
(Fig. 6)
- 6 -